Use A Hands Applied Lacquer Fresh paint Job For An Auto

A high-quality hand-rubbed Stop requires various coats of lacquer.


A well-done, hand-rubbed finish on an vehivle adds that Ending touch of congregation to a restoration business. Car painters cook not utilize acrylic lacquer as even as they did in the ended, due to its toxicity and owing to the Stop is besides brittle than urethane or enamel. Yet so, it is even the ace Election for plam rubbing owing to, unlike whitewash, it does not gain to cure. Successive coats blend with preceding ones to constitute a continuous--rather than layered--finish that rubbing enhances.


Instructions


1. Mask off the areas that you won't stain. Utilize masking paper for the windows, bumpers, tires and other larger areas.


2. Sand gone all rust and brush on rust preventative. Fill dents and holes with item filler. When the filler has cured, sand these areas down with an orbital sander and 120-grit sandpaper, feathering the edges into the item to build a smooth transition. Stop feathering by artisan with 220-grit sandpaper to remove scratches.


3. Sand between each coat with 600-grit sandpaper. Do not sand the last coat.6. Let the finish cure for several days. When you are finished, turn the nozzle 90 degrees and spray in an up-down pattern.


4. Apply one coat of primer and then one coat of the lacquer color. Sand the lacquer coat with 400-grit sandpaper and apply a second coat. Repeat until the color tone and sheen are satisfactory. This may take anywhere from 6 to 10 coats.


5. Apply two or three coats of clear-coat lacquer on top of the color to supply a surface that can be buffed without altering the color tone. Spray primer and lacquer. Adjust the spray gratuity of the gun and the air impact from the compressor to receive a vertical fan that is about 8 inches wide from a distance of 6 inches. Hold the gun 6 inches from the surface and spray in a continuous left-right pattern from end to end, overlapping by about half the width of the spray pattern on each pass.


Rub it out with a damp rag and polishing compound. Do not over-polish or you will go through the finish. Apply wax and buff it for a final touch.