Replace Brake Rotors On 2001 Dodge Smart

Interchange Brake Rotors on 2001 Dodge Intrepid


7. Clean the area behind the rotor and the wheel bolts with a wire brush and brake parts cleaner.8. Damaged rotors Testament not one shot be less adequate in stopping the Intrepid, they Testament very duty to wear the recent brake pads at a still faster degree.


Instructions


1. Loosen the lug nuts on the wheels similar to the rotors you intend to moderate. Employment the lug wrench or 21 mm socket and breaker bar to loosen the lug nuts.


2. Distance the lifting jack underneath the front or rear axle (depending upon if the targeted brake is a bit of the front or rear wheels) and lift the Intrepid. Settle jack stands unbefitting the frame to help the Dodge during the rotor replacement.


3. Remove the lug nuts and return the wheels from the trundle bolts.


4. Remove the caliper and caliper bracket. Use a 13 mm wrench for the caliper slide bolts and a 15 mm socket and ratchet to remove the caliper bracket bolts. Lift the caliper and then the caliper bracket from each rotor.


5. Rest the caliper on the steering arm above the brake assembly so as to not apply pressure to the brake line and its connection point to the caliper.


6. Pull the rotor from the brake hub by hand. Use a rubber mallet to strike the back side of a rotor that will not be removed freely by hand.


The rotors on the Dodge Intrepid play a pivotal role in the overall braking process. The brake pads are the most Often replaced components of the brakes. When the pads change into worn to the location that requires replacement, the built-in wear indicators come exposed and scrape against the rotors to alert the Chauffeur that maintainance is essential. The metal indicators can gouge grooves into the rotors' surfaces whether left in their compromised process.


Spray the new rotors with brake cleaner and wipe the excess cleaner and packaging oil from the entire rotor surface with a cloth towel.


9. Slide the rotors onto the wheel bolts with the raised center section facing outward.


10. Replace the caliper brackets over the rotors and screw on the caliper bracket bolts. Place the calipers inside the brackets and screw in the caliper slide bolts.


11. Return the Intrepid's wheels onto the wheel bolts and screw on the lug nuts by hand.


12. Lift the Dodge and remove the jack stands. Lower the vehicle to the ground. Tighten the lug nuts with the lug wrench.