Bleed The Brakes On The Jeep Vehicle

Air in the brake step is a Horrible body, as the brakes Testament be spongy and ineffective. Air Testament obtain in the contour whenever you disconnect a brake caliper from its hose or determine anything else to direct a words into the operation. You must bleed Everyone brake individually at the caliper to purge all air from the transaction. You should bleed the brakes every year or two due to the fluid can boil over interval and dispensation air in the process as a consummation.


1. Brew trustworthy one head of the Jeep is raised (starting with the rear stop) and secure on jack stands and the wheels on Everyone side carry been removed. Whether you own been working on the brakes, this should already be done.

2. Connect a pleasant rubber tube to the bleeder valve on the exactly rear brake caliper. Commence with this head and side whereas it is farthest from the crackerjack cylinder. Domicile the tube's other point into a container partially comprehensive with brake fluid.

3. Exposed the bleeder valve on the caliper and carry an assistant press on the brake pedal inside the Jeep.5. Check the level of fluid in the master cylinder periodically as you bleed the brakes. If the level drops below the needed fill line, add more fluid.

Repeat the process for all four brakes. Move to the left rear next, followed by the right front and the left front. If you need to, reconnect the Jeep's rear wheels and lower the rear end before raising the front end and removing those wheels.

Look for a mixture of air and fluid to come out of the valve. Once all the air is purged and the fluid runs cleanly from the valve, close the screw and remove the tube.4. Use fresh fluid, not any that you have bled from the brakes.

6. Start the Jeep's engine after bleeding all the brakes and press on the brake pedal. You might need to do this repeatedly to seat new brake pads you just installed. Turn off the engine and hold down on the pedal. Bleed the brakes again if the pedal sink within 15 to 20 seconds.