Tools Required To Do Body Work

Tools Needed to Engage in Oppose Duty

The tools needed for entity profession are willingly available for do-it-yourself item repair. Most of the exertion can be done with basic participation tools, nevertheless there are a infrequent faculty tools needed besides. An assortment of oppose hammers, sanding blocks, intent putty spreaders and a microscopic slide hammer or stud gun Testament purchase you started. The blocks should be Supple Sufficiently to comply to the contours of the object so waves and low spots are not caused. Three sizes are all you longing; they can be purchased as a establish at the community dye advantage.Intent filler spreaders can as well be purchased as a establish.

The pick hammer is Apartment lodgings on one side and pointed on the other, allowing it to flatten warps or dents and lower giant spots during a project. The heel dolly is rounded on one side and Apartment lodgings on the other, allowing it to be placed on the crosswise side of the metal as you tap with the hammer to straighten curved metal.

Sanding blocks and come in a Broad heterogeneity of shapes and sizes. A grinder, dual-action sander and emulsion gun round absent the file.

Hand Tools

Thing hammers and dollies come in a diversification of shapes and sizes. Hundreds of dollars can be spent on these parts, on the other hand the most positive are the pick hammer and heel dolly.

These should be Numb Sufficiently To admit administration of filler thickness, on the contrary Supple Sufficiently to comply to contours. Skilled spreaders own a minimal vastness of filler to be used, resulting in far less sanding extent.

Grinders and Sanders

Grinders and sanders acquiesce the brisk Emigration of facts and shaping of reason filler. The electric versions of these tools functioning great for home body work and are typically cheaper than the air-powered versions.

Grinders remove paint to bare metal quickly and efficiently for feather edging a scratch. This tool is also a must for rust removal and weld smoothing during a patch panel repair.

A dual-action sander is used to smooth and finish body filler and primer coats when prepping for paint. This sander moves in a random pattern to prevent deep scratches. When used with progressively finer sand paper, it helps to prep large flat surfaces quickly.

Slide Hammers and Stud Guns

A small slide hammer, also called a dent puller, is used to pull dented metal back into shape. Holes are drilled in the dent, and a screw is fitted to the head of the slide hammer and screwed into the holes. The slide is pulled back to pull the metal back into shape. After the metal is back in roughly the original shape, the holes are welded and ground down smooth.

A lot of work can be eliminated by using a stud gun. The stud gun welds a small metal stud to the dented metal, then the slide hammer is attached to the stud to pull the metal back into shape. Then the studs are cut off and ground down. This saves hours of welding and grinding.

Paint Guns

There are two types of paint guns used today. The standard gun uses high pressures to finely atomize the paint as it is sprayed on to the surface. This results in a smooth surface, but a lot of over-spray.

Most auto body shops today use the H.V.L.P gun. H.V.L.P means high-volume low-pressure. It works at a lower pressure and applies paint quicker with less over-spray. This gun type is harder to work with since the volume of paint applied tends to run or leave a rough texture until you get used to it.

Both types of paint guns are available in gravity feed or siphon styles and are generally available at the local paint supply.


The tools required for good body work do not have to be expensive or difficult to use. Proper use of the basic tools and patience will result in a quality paint job you can be proud of.