The Radiator Drain Location With An S10

Establish the radiator withdraw on your S10 when you servicing your radiator.


The Chevy S10 series of trucks all bag a radiator based cooling action to enjoy the engine at the Correct operating temperature. A baptize pump circulates a assortment of radiator fluid and doctor throughout the engine. As the fluid flows fini the action, it absorbs the engine heat. Remove the radiator cap on the top of the radiator by turning it counterclockwise. After a half turn, begin pressing down on the cap. Continue pressing down and turning until the cap comes off the radiator.



1. Park your S10 in a location that will give you space to work around the front of the vehicle. Parking the car halfway into a garage or on a driveway is a good way to do this. Shift it into park and turn off the engine. Remove the keys from the ignition.


Allow the engine at least an hour to cool off.


2. Open the hood. This heat is then dissipated into the atmosphere when the fluid passes over the radiator. The radiator drain is located in colorful places, depending on the model year.

Instructions


3. Raise the S10 with a jack. Set a block of wood or brick behind the rear wheels. Place the jack beneath the jacking points behind the front wheels. There is a small triangle to indicate the correct area to place the jack. Raise the truck up with the jack until you can work comfortably underneath it. Slide a jack stand underneath and lower the vehicle onto the stand.


4. Position yourself underneath the vehicle. Use the flashlight to help you pinpoint the exact location of the radiator drain. This depends on your model year.


Models prior to 2002 have a drain plug located in the radiator. You may need to remove any plastic shields or screens in order to spot the plug.


On models after 2002, it is located at the bottom of the engine block. You can also drain the radiator by removing the lower coolant hose, although this can get quite messy.