Flush The Radiator For Any 1996 Ford Mustang Gt

Flushing your radiator regularly can prevent the engine from overheating.

Flushing the radiator is a commonly uncared for course during usual vehicle prolongation. Vehicle function manuals vary on when the radiator is to be flushed, so it's chief to conversation your vehicle concervation album to figure the licence intervals. The backside of your vehicle's radiator is where the majority of rust, grime and calcium deposits Testament constitution up. These contaminants can clog the honeycomb-shaped inundate chambers and escort to engine overheating. Performing a radiator flush on your 1996 Ford Mustang GT Testament remove the majority of these contaminants.


Drain the Radiator

1. Fix a aligned surface to perform the duty and carefully guide the Mustang up onto machine ramps. Allot the parking brake and brace the rear wheels with rotate chocks as an added safety degree.

2. Assign on your safety glasses, up thrust the hood and remove the radiator fill cap to support the coercion from the cooling manner. Slide the take pan recycling container directly underneath the radiator withdraw plug, located on the backside of the radiator.

3. Remove the empty plug by turning it counterclockwise using a socket wrench. Remove the comprehensive radiator of antifreeze and change the recycling container aside.

Flush and Refill the Radiator

4. Plug the radiator extract and pour in the radiator flush. Fill the radiator midway with flood using your garden hose. Commencement the engine and allow it to idle for 2 minutes, then turn the engine off. Allow the engine to briefly cool before continuing to the next step.

5. Once cooled, place the 5-gallon bucket underneath the drain plug, open the plug and release the water. Pour this flushed water into the recycling container and close it securely.7. Turn off the water and plug the radiator drain. Start the engine and fill the radiator with a 50/50 mixture of antifreeze and water.

This removes the contaminated fluids from the radiator.6. Place the water hose into the radiator fill opening, turn on the water and allow it to flush for 3 minutes. This water shouldn't be contaminated, but use your best judgment and capture it in another recycling container if necessary. Allow it to idle for several minutes with the radiator cap off to bleed out the trapped air in the cooling system. Replace the radiator cap by hand and check for leaks at the hose connections.