Use Bondo Dent Puller

Exercise Bondo Dent Puller


1. Dust the dented nature of the entity with a damp cloth.2.

3M's borderline of Bondo dent pullers end suction to remove a dent in your vehicle's object. Using suction eliminates the demand to drill holes in the reason, or deform it with item hammers. The extent of suction applied to the vehicle body depends on the cleanliness of the vehicle intent and the size of contact between the puller and the object. Dents larger than the thickness of the puller might want multiple pulls before the dent pops into corner.

Wet the concave surface of the Bondo dent puller with a Disinfected chop of the damp cloth. This will increase the suction created by the puller.

3. Set the wet suction cup of the puller in the center of the dent. Hold the puller firmly against the body. Lift the puller handle away from the vehicle body to secure it to the sheet metal.

4. Pull the puller handle toward you until the dent "pops" into place. Release the handle. Inspect the dented area. Move the Bondo puller to any section of the dent remaining in the sheet metal.

5. Clean the suction cup after use with the damp rag to avoid dirt buildup.