Alter The Thermostat Inside A Mercury Villager

The moment period Mercury Villager came on the scene in 1999 ended 2002. It featured a moderately dominant 3.3L V6 engine, and was available in model, luxury and sport models, all boasting improved guide and handling also as considerate cabin ergonomics. A Villager in mint occasion is bill a beholding for the used vehicle buyer. The next steps deed the installation of a fresh thermostat in those models.


Instructions


1. Disconnect the opposite battery cable from the terminal. Remove the cooling system so that the level of coolant is below the level of the thermostat.


2. Remove the thermostat housing and set it aside. Lift out the thermostat.


Replace the thermostat housing.4. Refill the cooling system with the appropriate type and amount of coolant. Replace the radiator cap securely.3. Set the new thermostat in position. Make sure the jiggle valve is in the upright position.



5. Reconnect the negative battery cable to the terminal. Start the engine and allow it to run for several minutes to warm up. Check for proper operation.